Call for Availability
800.941.2446
Lectrosonics SRc-5P Block A1 470.100-537.575 Camera Slot Dual UHF Receiver.
The SRc5P and SRc consists of two separate receivers built into a single, ultra compact housing with adapters for video camera receiver slots and for stand-alone use. Digital Hybrid Wireless® technology provides superb, compandor-free audio quality and compatibility with other wireless systems. The RF performance is extremely stable over a very wide temperature range, making the receiver perfectly suited to the rough environmental conditions found in field production.
DSP compatibility modes allow the receiver to be used with a variety of Lectrosonics systems, other brands of wireless systems and with Lectrosonics IFB transmitters.
- Fits camera “slots,” Lectrosonics Duopack adapter and Octopack multicoupler, and operates stand-alone with various adapters
- Tunes over a 75 MHz range* (3 blocks)
- Dual receiver design for two channels with phase switched diversity or single channel with ratio diversity operation
- Digital Hybrid Wireless® with compatibility modes for use with other transmitters
- Tracking front-end filters for high performance in tough RF environments
- LCD with RF spectrum scanning
- SmartSquelchTM DSP-controlled, noise based filtering and squelch
- DSP-based pilot tone for squelch control
- IR sync port for quick transmitter setup (LMb, LT, HHa, HMa, & SSM)
- SmartTune operation for quick and confident frequency selection
Lectrosonics SRc-5P Block A1 470.100-537.575
Frequency selection steps:
Selectable; 100 kHz or 25 kHz
Receiver Type: Dual conversion, superheterodyne
IF Frequencies: Ch.1: 248.450 MHz and 350.000 kHz Ch. 2: 243.950 MHz and 250.000 kHz
Frequency Stability: ±0.001 %
Front end bandwidth: 20 MHz @ -3 dB
Sensitivity 20 dB SINAD: 1.0 uV (-107 dBm), A weighted 60 dB Quieting: 2.2 uV (-100 dBm), A weighted
Squelch quieting: Greater than 100 dB typical AM rejection: Greater than 60 dB, 4 uV to 1 Volt
Modulation acceptance: 85 kHz Image and spurious rejection: 85 dB Third order intercept: 0 dBm
Diversity method: SmartDiversityTM phased antenna combining or Ratio Diversity using both receivers for a single audio channel
FM Detector: Digital Pulse Counting Detector operating at 250 and 350 kHz
RF spectrum analyzer: Coarse and fine scanning modes for RF spectrum site survey
Antenna inputs: 50 Ohm; SMA female connectors
Audio output connectors: • Interchangeable D connector adapters for camera slot interfaces • Dual TA3 male (mini XLR) balanced output adapter • Balanced output adapter with fixed cables Front panel audio output (5P model): Control panel TA5M with two balanced outputs
Audio output level: Adjustable -50 to +5 dBu in 1 dB steps; unbalanced output is 6 dB lower
Audio channel crosstalk: -80 dB or better
Front Panel Controls and Indicators: • Sealed panel with membrane switches • LCD monitors pilot tone; antenna phase, receiver battery level; transmitter battery status; audio level, RF level Audio test tone: 1 kHz, -50 dBu to +5 dBu output (bal); 1% THD