Skip to main content
Manufacturer
Lectrosonics M2T IEM / IFB Transmitter (no Dante Module)
MPN: M2TND

Call for Availability

800.941.2446

Product Details

Lectrosonics M2T IEM / IFB Transmitter (no Dante Module)

Description

The M2T half-rack transmitter houses two independent stereo transmitters allowing for up to four stereo or dual-mono transmissions in a single rack space.

The Lectrosonics Duet The HD of In-Ear Monitoring


Nick shares the important features of how the Lectrosonics Duet System will work for you.  The Lectrosonics digital wireless monitor (IEM) system, the Duet. The new system consists of the M2T dual-stereo half-rack transmitter and M2R diversity belt pack receiver. The Duet covers the UHF frequencies of 470-608 MHz in a single range, uses digital modulation for transmission, and can accept analog or Dante digital inputs. The new system is designed and developed with professional touring, installation, theater, film making and broadcast customers in mind.

The audio inputs can be individually configured to be analog or Dante compatible. The analog input connectors arefull size XLR/TRS combo types for balanced line level analog signals while the input preamp circuits use aspecial balanced amplifier with very high common mode rejection to minimize hum and noise. A Dante™ Ultimo™ interface via dual RJ45 connectors accepts Dante networked audio inputs and can cascade the digital stream to additional units via CAT6 cables. An additional RJ45 jack provides an Ethernet connection for programming and control via Wireless Designer™ software and a USB jack on the front panel allows for firmware updates. The transmitter features a full color, backlit LCD for high visibility in any environment, while the chassis is all-metal and can be racked singly or in pairs using included rack mount hardware. 

  • IEM (Wireless Monitor) with digital RF transmission
  • 24-bit digital audio
  • 2 independent stereo audio transmissions per 1/2 RV enclosure
  • USB port for firmware updates
  • Fully Dante™ compatible
  • IR (infrared) port for fast setup
  • Up to 50 mW per Rf carrier
  • All metal housing
  • Compatible with Wireless Designer™ Software

 

Product Specification

Specifications
RF Power Output: 2 RF carriers, 25 mW, 50 mW; adjustable.
Antenna Output: 2 x BNC sockets
Operating Frequencies: 470.1 – 607.975 MHz
Frequency Selection Steps: 25 kHz
Frequency Stability: ± 0.002%
Modulation: 8 PSK
Emission Designator: 200KG7E
Spurious Radiation: >90 dB below carrier
Equivalent input Noise: –128 dBV
Audio Frequency Response: 20 HZ - 15 KHZ, -3 dB
Audio Input: -10 dBv or +4 dBu settings w/ ±5 dB trim
Audio Input Jack: 4 x combo XLR/TRS connectors
Dante Connection: 2 x RJ45. Internally routable with Ultimo 4x4 module
Ethernet Connection: RJ45
USB Connection: Micro USB on front panel for firmware updates
IRDA: IR transceiver for sync of receivers
Input impedance: Line: 2k Ohm Headphone jack ¼ inch stereo jack
Power Requirements: 9-18V DC
Power Consumption: 5 Watts
Dimensions: Height: 1.750 in. / 44.45 mm Width: 8.375 in. / 212.7 mm Depth: 7.750 in. / 196.8 m.
Specifications subject to change without notice.